Filter
Top Products
26
3. No audio and the front panel indicator LED is
blinking slowly.
• The Nº432/431 is in standby. To take it out of standby,
press and release the standby button. The Nº432/431 will
power on.
4. No audio and the front panel indicator LED is
blinking rapidly, remaining lit most of the time.
• Examine ~ac mains connections to ensure the power cord
is connected to the ~ac mains connector and the electrical
outlet.
• Power cycle the Nº432/431 with the power button, waiting
at least 10 seconds between powering the Nº432/431 off
and on.
• Contact an authorized Mark Levinson dealer.
5. No audio and the front panel indicator LED is
blinking rapidly, remaining lit about half of the
time.
• A signal-related fault condition is present, probably either
a DC offset or an over-current condition. If this occurs:
a. Power the Nº432/ 431 off with the power button.
b. Disconnect the input signal and loudspeaker wires.
c. Wait 10 seconds.
d. Power the Nº432/431 on with the power button.
e. Bring the unit out of standby by pressing and releasing
the
standby
button.
If the Nº432/431 powers on, repeat these steps, reconnecting
input signal and loudspeaker wires one at a time to
determine what is causing the fault condition. Remember
to power the Nº432/431 off with the power button before
making or breaking connections. If the Nº432/431 does
not power on, there is an internal failure. Contact an
authorized Mark Levinson dealer.
6. No audio and the front panel indicator LED is
blinking rapidly, remaining unlit most of the time.
• A thermal-related fault condition is present, which causes
the Nº432/431 to enter sleep mode. Once the heat sinks
have cooled below 85°C (158˚F or 358K), the Nº432/431
can be taken out of sleep mode with the standby button.