Filter
Top Products
CONNECTING YOUR AMPLIFIER
Setting up your amplifiers is rather easy.
1. Connect all source components (turntable, CD, Tuner, Tape DAT, etc.) to
your preamplifier.
2. Connect the RCA interconnects from the output of the preamplifier or
switching center to the RCA input on the back of the amplifiers.
3. Connect the hot or "+" speaker cable to the red binding post and the common
or "-" speaker cable to the black binding post. Ensure that the other end of
the cable is connected correctly to the speaker. Tighten the binding posts by
hand. If you use a nut-driver (3/8") do not over-tighten the posts or you
may break the connections inside the amplifier.
4. Ensure that the "mains" switch on the front panel is in the "off" or "0" posi-
tion.
5. Turn on Preamplifier and any source components you plan to use.
6. Plug amplifier into wall outlet.
7. Switch the square mains power switch to the ON position and allow the
amplifier a minute or so to 'warm up'.
9. Turn up the volume and enjoy.