Filter
Top Products
CONNECTING YOUR AMPLIFIER
Setting up your amplifier is rather easy.
1. Connect all source components (turntable, CD, Tuner, Tape DAT, etc.) to your preamplifier.
2. Connect the interconnects from the output of the preamplifier or switching center to the
RCA input on the top rear of the amplifier.
3. Connect the hot or "+" speaker cable to the red binding post and the common or "-"
speaker cable to the black binding post (See diagram 2). Ensure that the other end of the
cable is connected correctly to the speaker. Tighten the binding posts by hand. If you
use a nut-driver (3/8") do not over-tighten the posts or you may breaak the connection
inside the amplifier.
4. Insure that the "mains" switch on the front panel is in the "off" or "0" position.
5. Turn on Preamplifier and any source components you plan to use.
6. Plug amplifier into wall outlet.
7. Turn on the amplifier and allow it to 'warm up' a minute or so before playing any audio
signal.
8. Turn up the volume and enjoy.