Filter
Top Products
CONNECTING YOUR AMPLIFIER
Setting up your amplifier is rather easy.
1. Connect all source components (turntable, CD, Tuner, Tape DAT, etc.) to your
preamplifier.
2. Connect the interconnects from the output of the preamplifier or switching center
to the RCA input on the top rear of the amplifier.
3. Connect the hot or "+" speaker cable to the red binding post and the common or "-
" speaker cable to the black binding post (See diagarm 2). Ensure that the other
end of the cable is connected correctly to the speaker. Tighten the binding posts
by hand. If you use a nut-driver (3/8") do not over-tighten the posts or you may
breaak the connection inside the amplifier.
4. Ensure that the "mains" switch on the front panel is in the "off" or "0" position.
5. Turn on Preamplifier and any source components you plan to use.
6. Plug amplifier into wall outlet.
7. Turn on the amplifier and allow it a minute or so to 'warm up' before playing any
audio signal.
8. Turn up the volume and enjoy.