Filter
Top Products
S
tep 1: The radio chassis is designed to be “Panel
Mounted” through a opening in the mounting panel.
See the installation part of this manual for panel
mounting.
Step 2:
Bring all wiring for the connection of the
unit (including the antenna) through the mounting
hole. Connect the wiring as follows:
Yellow Wire: Connect this wire to a constant +12
volt power source (a power source that is not con-
trolled by the ignition key).
Red Wire(w/Fuse): Connect this wire to a switched +12
volt power source (a power source turned on and off
by the ignition key). The fuse has a rating of .5A.
Blue Wire: Connect this wire to the (+) power
antenna activation circuit. If no power antenna
exists, tape-off the end of this wire to prevent short-
ing out of the unit.
Black Wire: Connect this wire to the frame of the
vehicle (ground). This wire is the chassis grounding
wire for the unit.
White Wire: Connect this wire to the Left Main
Speaker (+) positive terminal or wire.
White Wire with Black Stripe: Connect this wire to the
Left
Main
Speaker (-) negative terminal or wire.
Green Wire: Connect this wire to the Left Remote
Speaker (+) positive terminal or wire.
Gre
en Wire with Black Stripe: Connect this wire to the
Left
Remote
Speaker (-) negative terminal or wire.
Gray Wire: Connect this wire to the Right Main
Speaker (+) positive terminal or wire.
Gra
y Wire with Black Stripe: Connect this wire to the
Right
Main
Speaker (-) negative terminal or wire.
Purple Wire: Connect this wire to the Right Remote
Speaker (+) positive terminal or wire.
Purple
Wire with Black Stripe: Connect this wire to the
Right
Remote
Speaker (-) negative terminal or wire.
Red/White RCA Connectors: Two sets of line out
cables are provided for connections to external
amplifiers.
Note: This unit is designed to connect to (4) four
speakers. If the installation only requires (2) two
speakers, use the White and Gray wire sets to con-
nect the speakers.
Wiring
9
WARNING!
Any wires left unconnected must be taped-off
or capped off to prevent shorting.
DO NOT connect speaker ground wires together.
DO NOT connect speaker ground wires to the
chassis of the vehicle.
DO NOT connect front and rear speaker wires
together.
FAILURE TO FOLLOW ANY OF THESE WARN-
INGS WILL RESULT IN DAMAGE TO THIS
UNIT AND VOIDS THE WARRANTY.