Filter
Top Products
6
INSTALLATION
The unit can be installed under a cabinet or on top of a counter.
Such locations would include mounting under a kitchen cabinet,
living room cabinets or under a cabinet or ledge in a bedroom.
The unit can also be installed on a counter top (clock radio style).
1. Locate a suitable spot for installation. Regardless if the
installation is under counter or counter top, the minimum
space required is 14.5" (W) x 9" (D) x 4-1/4" (H). Make sure
to compensate for the wiring that will exit the back of the unit.
2. Remove the "U" shaped mounting bracket by releasing the
thumb screws (4 pieces) on the side of the unit. Use the
bracket as a drill guide and drill four 1/8" holes. If you plan to
use self tapping type screw, you can place the bracket in the
proper location and power drive the mounting screws in
place. Install four (4) mounting screws to secure the bracket.
3. Slide the unit onto the bracket and install the four (4) thumb-
screws by hand. Set the unit into it's final position and finish
tightening the screws.
Note: The unit can be tilted about 10 degrees in the
event that the mounting surface is not level or the
unit is being installed on a counter top as a clock
radio. Place the unit in the position desired and
tighten the thumb screws.
LS9600UCDW/LS8600UCDW Manual 5/29/02 11:07 AM Page 6