Filter
Top Products
9
display
intensity
monitor record select balance
inverted
polarity
mono
123456
standby
mode
mute
987
321 5
10
64
PREAMPLIFIER Nº 380S
Front Panel
1 DISPLAY INTENSITY BUTTON
Cycles among four levels of brightness (including “off”) for the display, al-
lowing adjustment for various ambient lighting conditions. When “off,” the
display will turn on for a few seconds whenever a setting is changed. When
used in conjunction with certain compatible Mark Levinson components,
this button will control the display intensity of all linked components. (For
more information, see “Linked Functions.”)
2 ALPHANUMERIC DISPLAY
Provides a wide range of information concerning the operational status of
the Nº380S. The information displayed depends on the operating mode the
Nº380S is in (determined by the mode button). The information displayed
is summarized below:
monitor Selected (audible) Source and Volume
record Select “RECD” and Source to be recorded
balance Direction and Magnitude of Offset
In addition, when used with Mark Levinson power amplifiers that incorpo-
rate our communications link circuitry, this display is used to indicate the
presence of a fault condition (if any) in the amplifier. Please refer to the
owner’s manual of your amplifier for more information. For more detailed
information on the preamplifier’s use of this display, see “Operational
Modes.”