Filter
Top Products
11
2. Connect the bridging cable between the left- and right-channel
XLR-type input connectors, taking care to insert the correct cable
end into its designated channel. You may fabricate such a cable
according to Figure 12; it's also available through your Mark
Levinson dealer as part of a single-ended bridging kit.
Note: If fabricating the bridging cable, be sure to use high-
quality audio interconnect cable (such as Madrigal HPC).
21
3
Left-channel
XLR male
line-mount
(rear view)
21
3
Signal ground (shield)
Right-channel
XLR male
line-mount
(rear view)
Signal hot (center conductor)
22-guage
buss wire
22-guage
buss wire
Figure 12: Single-ended
bridging cable
3. Connect the left-channel + (positive or red) output post of the
Nº29 to the + (positive or red) input terminal of the appropriate
loudspeaker. Connect the right-channel + (positive or red) output
post of the Nº29 to the – (negative or black) input terminal of the
same loudspeaker.
4. Repeat this procedure for the other Nº29 to be bridged.