Filter
Top Products
10
•Iftheinternaltemperatureagaingetstoohot,
the shutdown process repeats. Should this
happen,makesurethatairowtotherearofthe
cabinet is not restricted. If the ambient air
temperature is very warm, try pointing a small
fantowardtherearpaneltoincreasetheairow
through the fins.
Driver Protection
Each driver has its own compression circuit, which
helps protect them from damaging transient peaks. The
compressors are designed to be transparent and are not
noticeable under normal operating conditions.
Input Signal Wiring
You should use high-quality, shielded cable to
connect the signal source to the INPUT jack on the
TH-15A.
• Highqualitymicrophonecablesworkwell.
• Foilshieldedcablesarecommonlyusedforaudio
wiring.
• Thebettertheshield,thebettertheimmunity
from externally induced noise (like EMI and
RFI). Route the cable away from AC power cords
and outlets. These are common sources for hum
in an audio signal. You can purchase quality
cables from your Mackie dealer.
Placement
The TH-15A loudspeaker is designed to sit on the
oororstage.Itcanbepole-mountedviathebuilt-in
socket on the bottom of the cabinet. Be sure the pole is
capable of supporting the weight of the TH-15A.
WARNING: The cabinet has no rigging
points and is not suitable for rigging.
NEVER attempt to suspend the TH-15A by
its handles.
As with any powered components, protect them from
moisture. If you are setting them up outdoors, make
sure they are under cover if you expect rain.
Protection Circuits
There are several protection mechanisms designed
into the TH-15A to safeguard the loudspeakers and
amplifiers from inadvertent damage.
CAUTION: The protection circuits are
designed to protect the loudspeakers under
reasonable and sensible conditions. Should
you choose to ignore the warning signs
(i.e., frequent OL LED indications, excessive distortion),
you can still damage the speakers in the TH-15A by
overdriving them past the point of amplifier clipping. Such
damage is beyond the scope of the warranty.
Overexcursion Protection
A 12 dB/octave high-pass filter at 40 Hz just prior
to the low-frequency amplifier prevents very low
frequencies from being amplified. Excessive low-
frequency energy below 40 Hz can damage the woofer by
causing it to “bottom out,” also known as overexcursion,
which is equivalent to a mechanical form of clipping.
Thermal Protection
All amplifiers produce heat. The TH-15A is designed
to be efficient both electrically and thermally.
The amplifier module is mounted on a large
heatsink, which is cooled by convection where cool air
is drawn over the rear panel, carrying the heat away.
In order for this convection cooling to work efficiently,
it is important to provide adequate airspace behind
the loudspeaker. When you position the TH-15A, we
recommend leaving at least six inches of air space
behind it.
•Ifforsomereasontheinternaltemperature
gets too hot, a built-in thermal switch activates
and turns off the amplifier. This protection
operates independently for the low-frequency and
high-frequency amplifiers. Therefore, it is possible
for only the low frequency or high frequency
amplifier to shut down while the other remains on.
•Whentheampliercoolsdowntoasafe
temperature, the thermal switch resets
and normal operation resumes.