Filter
Top Products
Appendix B:
Connections
“XLR” Connectors
TheHD1501hastwofemaleXLRinputsthataccept
balanced line-level signals. When connecting a balanced
signal, be sure it’s wired per AES (Audio Engineering
Society) standards:
XLR
Pin 1 – Shield (Ground)
Pin 2 – Hot (+)
Pin3–Cold(–)
TherearealsotwomaleXLRconnectorsonthe
HD1501 labeled full range. These are also wired
according to the AES standards listed above.
The full range connectors allow you to connect
several HD1501’s. Simply plug the signal source
(e.g., mixer output) into the HD1501 input jack, and
patch that subwoofer’s full range jack to the next
subwoofer’s input jack, and so on, daisy-chaining
multiple subwoofers.
There is a limit to how many you can
daisy-chain together. A general rule is to
maintain a load impedance ten times or
more than the source impedance to prevent
excessive loading on the source. For exam-
ple, if your mixer has an output impedance of 120 ohms,
then you can daisy chain up to nine HD1501s. This is
a load of 1222 ohms (HD1501 input impedance=11
kohms; 9 of these in parallel=1222 ohms). Since
microphones typically have a higher output impedance,
you should limit daisy-chaining from a mic source to
two HD1501s (assuming that loudspeakers are also
connected to the subwoofers).
Balanced XLR Connectors
Repair
For warranty service, refer to the warranty
information on page 17.
Non-warranty service for Mackie products is
available at a factory-authorized service center. To
locate the nearest service center, visit www.mackie.com,
click “Support” and select “Locate a Service Center.”
Service for Mackie products living outside the United
States can be obtained through local dealers or
distributors.
If you do not have access to our website, you may call
theTechSupportdepartmentat1-800-898-3211,
Monday-Friday, during normal business hours, Pacific
Time, to explain the problem. Tech Support will tell you
where the nearest factory-authorized service center is
located in your area.
13
Owner’s Manual
Owner’s Manual