Mackie 450 V3 Headphones User Manual


 
SRM350v3 and SRM450v3 Powered Loudspeakers
16
SRM350v3 and SRM450v3 Powered Loudspeakers
Appendix A: Service Information
Poor sound
• Isitloudanddistorted?Makesurethatyou’renot
overdrivingastageinthesignalchain.Verifythat
alllevelcontrolsaresetproperly.
• Istheinputconnectorpluggedcompletelyinto
thejack?Besureallconnectionsaresecure.
Noise
• Whatisthepositionofthegainknob?Itshould
beat(ornear)“mic”whenamicisconnected
andat(ornear)“line”whenaline-levelsignal
isconnected.Itshouldbe“off”forallunused
inputs.
• Makesureallconnectionstotheactive
loudspeakersaregoodandsound.
• Makesurenoneofthesignalcablesarerouted
nearACcables,powertransformers,orother
EMI-inducingdevices.
• IstherealightdimmerorotherSCR-baseddevice
onthesameACcircuitastheSRMloudspeaker?
UseanAClinelterorplugtheloudspeakerinto
adifferentACcircuit.
Hum
• Trydisconnectingthecableconnectedtothemain
inputjack.Ifthenoisedisappears,itcouldbe
a“groundloop,”ratherthanaproblemwiththe
SRMv3loudspeaker.Trysomeofthefollowing
troubleshootingideas:
• Usebalancedconnectionsthroughoutyoursystem
forthebestnoiserejection.
• Wheneverpossible,plugalltheaudioequipment’s
linecordsintooutletswhichshareacommon
ground.Thedistancebetweentheoutletsandthe
commongroundshouldbeasshortaspossible.
Repair
Forwarrantyservice,refertothewarranty
informationonpage23.
Non-warrantyserviceisavailableatafactory-
authorizedservicecenter.Tolocatethenearest
servicecenter,visitwww.720trees.com,click“Contact
TechSupport”andselect“LocateaServiceCenter
orDistributor”[3].ServiceforSRMv3loudspeakers
livingoutsidetheUnitedStatescanbeobtained
throughlocaldealersordistributors.
Ifyoudonothaveaccesstoourwebsite,youmaycall
theTechSupportdepartmentat1-800-898-3211,
Monday-Friday,duringnormalbusinesshours,Pacic
Time,toexplaintheproblem.TechSupportwilltellyou
wherethenearestfactory-authorizedservicecenteris
locatedinyourarea.
IfyouthinktheSRMv3loudspeakerhasaproblem,
pleasecheckoutthefollowingtroubleshootingtipsand
doyourbesttoconrmtheproblem.VisittheSupport
sectionofourwebsite(www.720trees.com)whereyou
willndlotsofusefulinformationsuchasFAQsand
otherdocumentation.Youmayndtheanswertothe
problemwithouthavingtopartwithyourloudspeaker.
Troubleshooting
No power
• Ourfavoritequestion:Isitpluggedin?Makesure
theACoutletislive[checkwithatesterorlamp].
• Ournextfavoritequestion:Isthepowerswitch
on?Ifnot,tryturningiton.
• IstheLEDonthefrontpanelilluminated?
Ifnot,makesuretheACoutletislive.
Ifso,referto“Nosound”below.
• TheinternalAClinefusemaybeblown.Thisis
notauserserviceablepart.Ifyoususpectthe
AClinefuseisblown,pleaseseethe"Repair"
sectionnext.
No sound
• Istheinputgainknobfortheinputsource
turnedallthewaydown?Verifythatallthegain
knobsinthesystemareproperlyadjusted.Look
atthelevelmetertoensurethatthemixeris
receivingasignal.
• Isthesignalsourceworking?Makesurethe
connectingcablesareingoodrepairandsecurely
connectedatbothends.Makesuretheoutput
levelcontrolonthemixingconsoleisturnedup
sufcientlytodrivetheinputsofthespeaker.
• Makesurethemixerdoesnothaveamuteonora
processorloopengaged.Ifyoundsomethinglike
this,makesurethelevelisturneddownbefore
disengagingtheoffendingswitch.
• Hasitshutdown?Makesurethereisatleast
sixinchesoffreespacebehindeachSRMv3
loudspeaker.
Poor bass performance
• Checkthepolarityoftheconnectionsbetweenthe
mixerandtheloudspeakers.Youmayhaveyour
positiveandnegativeconnectionsreversedatone
endofonecable,causingoneloudspeakertobe
out-of-phasewiththeother.
• Poorbassperformancemaybetheresultofbad
ACpower.Seethesectiontitled‘ACPower’on
page12forfurtherdetails.