Linn 3200 Stereo Amplifier User Manual


 
Connecting
Connecting to the mains supply
The unit can be connected to any worldwide mains voltage with no
adjustment. It incorporates Automatic Voltage Selection (AVS) and the
power supply automatically adjusts for the incoming mains supply.
This unit must be earthed. Use the earthed moulded mains lead
supplied. Never use an unearthed plug or adaptor.
Back panel connectors and switches
Speaker outputs
Amplified output for connection to loudspeakers.
GAIN
For increasing or reducing the gain.
IImmppoorrttaanntt
:
Only for use when a Linn AKTIV module is fitted to the channel.
If no AKTIV module is fitted, always leave set to 3 (default gain
setting). If an AKTIV module is fitted, this adjustment can be
used to finely tune the AKTIV system to match the room
acoustics.
AUDIO IN
For connection to the incoming audio signal.
AUDIO OUT
Allows the AUDIO IN signal to be relayed to another amplifier
channel or another device (e.g. subwoofer).
For balanced models, due to space restrictions on the back
panel, AUDIO OUT is not available on all channels.
Power switch
For switching the power to the amplifier on and off. Note - this is
not a standby switch but cuts the mains supply to the unit.
MAINS INPUT
See Connecting to the mains supply opposite.
Please see following pages for back panel diagrams showing
connectors and switches.
ENGLISH
4 AKURATE 2200
3200
4200
1
2
3
4
5
6
AKURATE 2200 3200 4200 6.5 15/5/07 08:48 Page 12