Linn 212 Speaker System User Manual


 
11
AKURATE Loudspeaker System
Owner’s Manual
AKURATE 221
English
Parameters
The AKURATE 221 speaker is equipped with seven adjustable parameters (see
next page) that enable you to alter its performance to suit your taste.
Note:
The parameters can only be adjusted when the AKURATE 221 speaker is not in
standby mode.
Adjusting the parameters
TToo sseelleecctt tthhee ppaarraammeetteerr yyoouu wwiisshh ttoo aaddjjuusstt::
Hold
FFEEAATTUURREE
.
Repeatedly press
UUPP
or
DDOOWWNN
until the letter for the desired parameter
appears.
Release
FFEEAATTUURREE
.
Repeatedly press
UUPP
or
DDOOWWNN
to change the setting.
A few seconds after the last key press the display
changes to
TToo rreessttoorree tthhee ddeeffaauulltt sseettttiinnggss::
Disconnect the AKURATE 221 speaker from the mains supply and wait for
the display to go blank.
While holding
FFEEAATTUURREE
reconnect the mains supply.
Continue to hold
FFEEAATTUURREE
until the display shows
H
A few seconds after releasing
FFEEAATTUURREE
the display changes to
HP OUT
AL OUT
A IN
-
-
Operation
When you have made all the required connections, switch on the mains supply.
Flashing bars will be shown on the back panel display for approximately 30
seconds. During this time the speaker’s servo circuitry is stabilising and no
audio will be issued. When the display changes to show the standby symbol (see
table below), the speaker is ready to receive an audio signal.
Whenever the AKURATE 221 speaker is disconnected from the mains supply
and then reconnected, wait until the standby symbol appears on the display
before playing a disc.
Operating modes
SSYYMMBBOOLLMMOODDEE MMEEAANNIINNGG
SSttaannddbbyy TThhee uunniitt iiss wwaaiittiinngg ffoorr aann aauuddiioo ssiiggnnaall
In this mode the unit consumes minimal
power.
OOnn TThhee uunniitt iiss ffuullllyy ppoowweerreedd--uupp
The unit will enter this mode as soon as it
receives an audio signal.
TThheerrmmaall SSttaannddbbyyTThhee uunniitt hhaass oovveerrhheeaatteedd
During very demanding, sustained use the
unit will go into Thermal Standby mode in
order to allow itself to cool down. When in
this mode the unit will not produce any
sound. The unit will return to On mode
when its temperature has dropped to its
operating level.
KKeeyy ttoo ssyymmbboollss