Filter
Top Products
Installation
For full details, see the
Advanced Features
manual, which can be found on the
Linn website at www.linn.co.uk. Alternatively, contact your Linn retailer or the
Linn Helpline (Helpline details are listed at the back of this manual).
For best results, we recommend that your KOMPONENT loudspeakers are
unpacked, installed and adjusted by an Authorised Linn Retailer.
Positioning
The KOMPONENT loudspeakers can be stand-mounted, wall-mounted or (in the
case of the satellite and centre models) shelf mounted.
If you wish to use the KOMPONENT 104 free standing, attach
the supplied rubber feet as shown.
See also the KOMPONENT stand / bracket assembly
manuals, supplied with the stands / bracket kits – also
available on the Linn website at www.linn.co.uk.
5.1 system suggested speaker positioning
Connecting
General
IMPORTANT. Before making any connections, switch off all products in your hi-fi
or AV system.
The terminals are hidden under a removable cover. To access the terminals,
unclip the cover by carefully pushing its edges inwards. If your connection and
cable-routing method allow, the terminal cover can sometimes be refitted after
making the connections.
Standard connection (Single-wiring)
TTeerrmmiinnaallss
The binding-post terminals can be used as sockets for the connection of 4mm
banana plugs or can be used as binding posts for the connection of bare wires
or spade-terminated cables by loosening the outer section of the binding post
(do not attempt to completely remove this outer section), inserting the cable or
terminal and re-tightening to clamp it in place.
3
KOMPONENT 110, 106 & 104
Owner’s Manual
Installation
English
Komponent 106
Komponent 120
Connect the
negative (-) or
black cable to any
of the black
KOMPONENT
terminals.
Connect the cable
marked positive (+)
or red to any of the
red terminals on
the KOMPONENT.
Banana PlugSpade-terminated Cable
Bared Wire Connection
ENG KOMPONENT 110_106_104 12/17/04 8:11 AM Page 6