Filter
Top Products
25Installation
3
Installation
Speaker Connection
Wireless connection
When you turn on the unit, subwoofer and
wireless receiver the connection will be
completed automatically.
When the connection is completed, you can
see the icon on the display window.
NOTE
• If the wireless connection fails again, check
whether there is any con ict or strong
interference (for example, interference
from other electronic devices) around your
location. After removal of the con ict or strong
interference, repeat the above procedures.
• The available length is 20 m for wireless
connection on open place.
LED indicator of wireless receiver
LED Color Operation
Blue The wireless receiver is
receiving the signal of the
wireless transmitter.
Red The Wireless Receiver is in
standby mode.
O
(No display)
The Wireless Receiver is
turned o .
NOTE
• If there is a strong electromagnetic wave
product nearby, interference may occur. Put the
unit (Wireless Receiver and main unit) away from
there.
• Be sure to match the speaker cable to the
appropriate terminal on the components: + to +
and – to –. If the cables are reversed, the sound
will be distorted and will lack bass.
• It takes a few seconds (and may take longer) for
the Wireless Transmitter and Wireless Receiver to
communicate with each other.
Wireless connection for
manually
You can set up wireless connection manually,
when your connection is not completed.
Refer to the “Connect wireless speakers” on
page 42.
HX995TZW-FD.BPANLLK_ENG_3803.indd 25HX995TZW-FD.BPANLLK_ENG_3803.indd 25 10. 10. 06 11:0710. 10. 06 11:07