Filter
Top Products
27
Symptom
Radio stations cannot
be tuned in.
The Remote Control
does not work
properly.
The front panel
display is too dim.
Cause
• The antenna is positioned or connected
poorly.
• The signal strength of the stations is too
weak (when tuning in with automatic
tuning).
• No stations have been preset or preset
stations have been cleared (when
tuning by scanning preset stations).
• The Remote Control is not pointed at
the Remote Sensor of the unit.
• The Remote Control is too far from the
unit.
• There is an obstacle in the path of the
Remote Control and the unit.
• The batteries in the Remote Control are
flat.
• Nothing is displayed on the front panel
display.
Correction
• Connect the antenna securely.
•Adjust the antennas and connect an
external antenna if necessary.
•Tune in the station manually.
• Preset the stations (page 23).
• Point the Remote Control at the Remote
Sensor of the unit.
• Use the Remote Control within about 23
ft (7 m).
• Remove the obstacle.
• Replace the batteries with new ones.
• Press DIMMER.
REFERENCE