Filter
Top Products
2-2
Basic Operation
Lexicon
1. Standby Button
Toggles the amplifier between on and standby. When the
amplifer is on, pressing this button places it into standby and
lights the red LED. When the amplifier is in standby,
pressing this button powers it on. When powered on, the red
standby LED will flash slowly until the amplifier begins
outputting audio. When this occurs, the red standby LED will
stop flashing and the blue channel status LEDs will light. This
will take a few seconds.
FRONT PANEL OVERVIEW
1 2
Note:
If the red standby LED flashes rapidly and the blue
channel status LEDs do not light, the incoming AC
voltage is too low or the temperature of the
transformer is too high. See Section 3 for
troubleshooting information.