Filter
Top Products
Listening to Presetted Stations
(after you programmed them)
Presetting Stations
UP TO 5 AM AND 5 FM STATIONS CAN BE STORED INTO THE PRESET MEMORIES.
(THEY WILL REMAIN IN MEMORY AS LONG AS THE BATTERIES ARE INSTALLED, OR
AC POWER CORD IS CONNECTED.)
1. Slide the CD/RADIO FUNCTION switch to RADIO position.
2.
Press the BAND switch to select AM or FM band, and press
the TUNING UP or DOWN button to select a station.
3. Press the radio STORE button,
M
will flash in the display.
4. While the
M
is blinking, press the radio PRESET button
(M1-M5) to store that station into that memory location.
NOTE: Steps 3-4 should be done quickly.
1. Slide the CD/RADIO FUNCTION switch to
RADIO position, the RADIO INDICATOR
LAMP will go on.
2. Press the BAND button to select the desired
wave band.
3. Tune to desired station by pressing the
TUNING UP or DOWN button. Each time the
button is pressed, the frequency changes.
5. Repeat the above steps 2 to 4 to store other 4 stations into memory.
6. Each memory location (M1-M5) can store 2 stations, one for AM, the other for FM.
NOTE: Before you disconnect the power (AC and Battery) of the set, make sure
the CD/RADIO FUNCTION switch is at the CD position, then you have
approximately 30 seconds to re-connect the power.` Otherwise, the
memories may be lost and need to be re-programmed.
RADIO OPERATION
4. To search for a station quickly (automatic tuning), keep the TUNING UP or DOWN
button pressed until the frequency starts to change rapidly. After tuning into a
strong station, the search stops.
5. If you tune into a FM stereo station,
will show in the display.
6. Adjust the VOLUME control to your listening preference.
7. If you prefer more bass, slide the BASS BOOST switch to ON position.
8. To turn off the radio, slide the CD/RADIO FUNCTION switch to CD position, and
the RADIO INDICATOR LAMP will go off.
10
BASS BOOST
FUNCTION
SWITCH
VOLUME
TUNING
BAND SWITCH
1. Slide the CD/RADIO FUNCTION switch to RADIO position.
2. Press the BAND switch to select the band you want (AM or FM).
3. Press the PRESET buttons M1-M5 to select the stations stored. You will receive the
station you stored into that preset memory location.
4. To shut off the radio, slide the CD/RADIO FUNCTION switch to CD position.