Filter
Top Products
IB-CD2086(AD)-WM-E-031705
You can use the AC power or batteries as a power source.
4
To a wall outlet
•
Replace all the batteries
with new ones when the
LCD display dims or the
player stops operating.
Before you replace all the
batteries, be sure to take
out the disc from the player
and remember to check the
Battery Safety Instructions
on Page 3.
•
If the discs do not play on
batteries, this means the
batteries are almost used
up. But the radio may
continue to play on these
weak batteries because it
uses less power than the
disc player.
TIP:
1.Connecting the AC power
Insert one end of the supplied AC power cord into the
socket located at the rear of the set, and the other
end into the 120V, 60 Hz standard household outlet.
2.Using the player on batteries
Insert 8 size “C” batteries (not supplied) into the
battery compartment as shown. Observe (+) and
(-) polarities.
BATTERY DOOR
(on the bottom of the set)
CHOOSING THE POWER SOURCES
Install Batteries as illustrated
NOTE:One blade of
plug and outlet is wider.
•
If the plug of the AC power
cord does not match your
outlet, do not force it.
Reverse it and try again.
The plug is polarized and
only fits one way into the
wall outlet and rear of the
set.
C
C
C
C
C
C
C
C
AC SOCKET
To use the player on batteries, disconnect the AC
power cord from both the outlet and the back of the
player.
IB-CD2086-WM-E-012005(WMA).pmd 3/22/2005, 5:52 PM5