Filter
Top Products
TROUBLE SHOOTING
Problem
Remedy
The power is not on.
Connect the AC power cord to a wall outlet
securely.
Make sure the batteries are inserted
correctly and they are fresh.
There is no sound.
Make sure the FUNCTION switch is in the correct
position.
Adjust the volume.
Unplug the headphones when listening through
speakers.
CD does not play.
The sound drops out.
The sound is weak or has poor
quality.
Replace all the batteries with new ones if they are
weak, or bring the set near a window, or rotate the
set.
The tape does not play or record
Make sure the recording tab on the cassette is in
place.
Make sure the FUNCTION switch is in the correct
position.
The tape does not erase
completely.
Clean the erasing head (see page 17).
Replace all the batteries with new ones if they
are weak.
The sound is weak/The sound
quality is poor.
Clean the heads, pinch roller and capstan
(see page 17).
General
CD player
Radio
Tape player
Cassette PLAY button pops up.
The tape has reached its end. Remove it, flip to the
other side and re-insert.
18
IB-CD103(SY)-WM-E-090402
The reception of FM/TV/WB band
is weak.
Adjust the length and the angle of the antenna to
change position for better reception.
Make sure the tape is inserted correctly.
Make sure that the CD compartment is closed.
Place the CD with the label side up.
Clean the CD.
Take out the CD and leave the CD DOOR open for
about an hour to dry moisture condensation.
Make sure the FUNCTION switch is at CD
position.
Clean the CD, or replace it if the CD is badly
damaged.
Place the player in a location free from
vibration.
Check if your batteries are fresh.
CD does not play while radio may
continue to play.
It is normal since the radio uses less power than
the CD player.
Tape jamming or tangling
Use only better quality tapes.
Do not use a cassette with more than 90 minutes.
Make sure there are no loose layers of tape visible
before inserting the cassette.