Filter
Top Products
CHOOSING THE POWER SOURCES
You can use the AC power or batteries as a power source.
4
To a wall outlet
NOTE: One blade of plug
and outlet is wider.
AC SOCKET
Battery compartment
IB-CD103(SY)-WM-E-090402
1. Connecting the AC power
cord
Insert one end of the supplied AC power cord into
the socket located at the rear of the player, and the
other end to the wall outlet.
2. Using the player on batteries
Insert 6 size C batteries (not supplied) into the
battery compartment.
To use the player on batteries, disconnect the AC
power cord from the player.
Tip
If the plug of the AC power
cord does not match your
outlet, do not force it.
Reverse it and try again.
This plug is polarized and
only fits one way into the
wall outlet and the back of
the set.
If the CD does not play
on batteries, this means
the batteries are almost
used up. But the radio may
continue to play on these
weak batteries because it
uses less power than the CD
player.
Replace the batteries when
the Power Lamp dims or
when the player stops
operating. Replace all the
batteries with new ones.
Before you replace the
batteries, be sure to take
out the CD from the player and
remember to check the
Battery Safety Instructions
on Page 3.