Lenoxx Electronics 1126 Cassette Player User Manual


 
IB-1126(CL)-WM-E-070506
TO INSERT THE TAPE
1.Open the cassette door by holding the door as shown and gently pulling
it to you.
2.Insert a recorded tape into the cassette holder ON THE DOOR.
3.Close the cassette door gently till it clicks shut.
CAUTION: Do not pull door too strongly, or you may damage the door. Treat
this set with care and it will last a long time.
TAPE PLAY
1.Check whether or not the tape is tight before it is inserted.
2.Open the cassette door by hand, face the side to be played toward you, and
insert the cassette tape. Close the cassette door.
3.Connect the headphones to the HEADPHONES jack and adjust the
headphones band for proper fit.
4.Press the PLAY button.
5.Adjust the VOLUME to control the sound level you like.
6.To skip portions of the cassette tape, press the FAST F. button.
7.To stop playing, press the STOP button, and the power source is also
shut off.
(This set has a built-in auto-stop and the tape mechanism will stop
playing and shut off when it reaches the end of the tape.)
8.To hear the other side of tape, flip it over and press PLAY .
To keep the tape from tangling, firmly
wind the tape before inserting it into the
player.
Use of a cassette with more than 90
minutes, such as C-120 (120
minutes), is not recommended. The
extreme thinness of this tape may
damage this set.
4
TO HEAR THE SAME SONG AGAIN
1.Remove the tape, flip it around to the other side and insert it.
2.Press the FAST F. button for a short time.
3.Remove tape, flip it around to the original side, re-insert and press the
PLAY button.
AUTOMATIC STOP - This set will automatically shut itself off when the tape
has finished playing, and the PLAY button will pop up.