Filter
Top Products
mIn bI
&T6 Perform a Remote Digital Loopback Test
&T7 Perform a Remote Digital Loopback Test and
Self-Test
&T8 Perform Local Analog Loopback Test and Self-Test
&V &V0 Displays Active and Stored Profiles
&V1 Display Last Connection Statistics
&W_ &W0 Stores the active profile as Profile 0
&W1 Stores the active profile as Profile 1
%E_ %E0 Disable auto-retrain
%E1 Enable auto-retrain
+MS? Displays the current Select Modulation settings
+MS=? Displays a list of supported Select Modulation
options
+MS=a,b,c,e,f Select modulation where: a=0, 1, 2, 3, 9, 10, 11,
12, 56, 64, 69; b=0-1; c=300-56000; d=300- 56000;
e=0-1; and f=0-1. A, b, c, d, e, f default=12, 1,
300, 56000, 0, 0. Parameter “a” specifies the
modulation protocol desired where: 0=V.21, 1=V.22,
2=V.22bis, 3=V.23, 9=V.32, 10=V.32bis, 11=V.34,
12=V.90,K56Flex,V.34......,56=K 56Flex,
V.90,V.34......, 64=Bell 103, and 69=Bell 212.
Parameter “b” specifies automode operations where:
0=automode disabled, 1= automode enabled with
V.8/V.32 Annex A. Parameter “c” specifies the
minimum connection data rate (300- 56000).
Parameter “d” specifies the maximum connection
rate (300-56000); Parameter “e” specifies the codec
type (0= Law, and 1=A-Law). Parameter “f”
specifies “robbed bit” signaling detection
(0=detection disabled 1=detection enabled)
MNP/V.42/V.42bis/V.44 mIn
mIn bI
%C_ %C0 Disable MNP Class 5 and V.42bis data compression
%C1 Enable MNP Class 5 data compression only
%C2 Enable V.42bis data compression only
%C3 Enable MNP Class 5 and V.42bis data compression
&Q_ &Q0 Direct data link only (same as \N1)
&Q5 V.42 data link with fallback options
&Q6 Normal data link only (same as \N0)
+DS44=0, 0 Disable V.44
+DS44=3, 0 Enable V.44
80 gk 3m-