Filter
Top Products
7 4
b) During CD mode:
Press the TOP button briefly to interrupt the playback of the CD.
Press again to resume normal playback of the CD.
Press the TOP button and hold for approximately 2 seconds to play
the first track of the current disc.
Press the INT button to play the first 10 seconds part of each track.
Press again to stop scan, while the currently selected track will be
played.
Press the RPT button to play the current track repeatedly. Press
again to cancel this function.
Press the RDM button to play all tracks on disc in random. Press
again to cancel this function.
16. CLOCK BUTTON
Press the CLK button briefly to display time on the display, then press
the CLK button and hold until the real time flashes on the display.
And then press the + or - button to adjust HOUR or MINUTE.
17. SCAN BUTTON
Press the SCN button to scan the radio frequency. If a valid signal has
detected, the current frequency will be hold and blinked for 5 seconds,
then press SCN again to stop scan and remain the current frequency;
otherwise, the radio will go on to scan the other radio frequency fiver
seconds later.
18. ST/MO BUTTON
During radio mode, press the ST briefly to select stereo or mono sound
mode.
19. INFRARED REMOTE CONTROL SENSOR
For connecting speaker harness better and prevent to
short circuit, please have connecting refer to the process
as follow.
Note:
Make sure use a speaker with 4 ohm load impedance to reduce
the distortion during high volume level.
+
+
+
+
FUSE 7A
YELLOW
ANTENNA PLUG
CONSTANT B+
BLACK(GND)
ACC RED (B+)
FRONT
REAR
RIGHT
SP
FRONT
WHITE
WHITE/BLACK
GREEN/BLACK VIOLET/BLACK
GREY/BLACK
GREY
VIOLET
GREEN
REAR
LEFT
SP
FUSE 0.5A
-
-
-
-
BLUE AUTO ANT
RCA LINE OUT
RED R
WHITE L
WIRING DIAGRAM