Filter
Top Products
owner’s manual
operation
preamp equalizer
Control/Connector Function
2
Power Indicator LED
This LED is illuminated when the unit is
properly powered, grounded and the remote
power has been turned on.
3
Equalizer Controls
This seven-band equalizer’s rotary controls
give you control over musical frequency
ranges.
7
Power Connection Connect to power source as follows:
+12: Connect a red wire of at least 12 gauge to
the car battery or other power source.
GROUND: Connect a black wire of at least 12 gauge
to car chassis for ground connection
REMOTE: Connect an orange wire to remote
activating (12V DC) wire of car stereo or other
head unit.
These rows of LEDs display the Preamp
Output Level. Left and right \channels are
displayed independently at peak levels.
1
LED Level Display
4
Volume Control
Allows adjustment of sound level for particular
program material or source.
• In a 2 Speaker system, the fader control
should be rotated to the position which
provides highest levels for both sets of
speakers.
5
Fader Control
• In a 2 Amplifier, 4 Speaker system, rotating
the knob to the FRONT side increases the
level of the front speakers; rotating to the
REAR side increase level of the rear speakers.
At mid position, both sets of speakers are at
maximum level
6
Line Channel Inputs RCA cables are used to connect the front
input signal from head unit or other source.
8
Front Channel Outputs
RCA cables are used to connect the front
channel ouputs to the front channel amplifier
inputs.
9
Rear Channel Outputs
RCA cables are used to connect the rear
channel ouputs to the rear channel amplifier
inputs.
s
)
5