1.) External Speaker
2.) Direct (SPKR Emulated)
4.) CD/Tape Input -
5.) Main FT Switch - this
-
-
3.) Headphone Jack -
this is a 2-conductor 1/4" speaker output jack. Rating is 8 ohms minimum.
The signal path to the internal speakers is disconnected when using this jack. Make absolute
sure that a 2-conductors speaker cord is used and it is plugged in to the external speaker
cabinet before plugging into this jack. Failure to do so could result in electrical shock or damage
to the amplifier. It is also highly recommended to turn off the AC mains power to the amplifier
before plugging or unplugging any speakers to this jack.
this is a 3-conductor. XLR output jack for plugging into Lo-Z
microphone inputs as found on PA or recording mixers. It is intended in place of external mics or
used as a built-in direct box. Great effort was made in emulating the actual speaker sound.
1/4" stereo jack connects a foot-switch to the amplifier. The tip selects the
rhythm or lead channel. The ring selects the effects active/off. This foot-switch is not included
with the amplifier. Kustom model KAC-FS201 is recommended to enjoy all the features.
this is a 3-conductor stereo jack. The amplifier’s internal speaker is
disconnected when this jack is used.
this is a 3-conductor 1/4” jack that allows playback from a Compact Disc or
Tape player. The volume is controlled by the device plugged into this jack.
7
HV 30 Back Panel™
Jacks located on chassis bottom in sequence shown above
12
3
4
5