9
GROOVE115C
Specifications
Model Groove 115C Bass guitar amplifier
Input Impedance
Output Power 600 Watts 3 Ohms @ 5% THD
Hum & Noise -60db Residual Noise, all level controls 0% (minimum)
27db Preamp output
15db Preamp output, Active
25db Tuner output
27db Direct output
32db Power amp gain
Amplifier Type Class B Descrete device Class B amplifier
Speaker 1 X 15" Specially Designed Eminence Speaker
USA/Canada 120VAC/60Hz, 800W nominal
Europe 230VAC/50Hz, 800W nominal
UK 230VAC/50Hz, 800W nominal
Australia 240VAC/50Hz, 800W nominal
Japan 100VAC/50-60Hz, 800W nominal
mm/kg 798 (Height) x 483 (Width) x 508 (Depth), 48 kg
Inches/Pounds 31.5 (Height) x 19 (Width) x 20 (Depth), 106 lbs
Dimensions
Power Requirements
Footswitch
System Gain
All measurements taken with 1KHz
inputsignal, Tone controls flat, Gain and
Volume Maximum. Measured ateffects
send outputjacks on rear unless noted.
200K Ohm
Use any standard tip-ring-sleeve cable
Any non-momentary two-button foot switch can be used.
Frequency Response 20HZ-20kHz
Actual response is tailored to speakers for accurate acoustical
response using a bass guitar as input.