Filter
Top Products
3
1Horn Attenuator: 3Speaker Input/Output:
This is a “volume” control for the These jacks can be used as an input
horn. To disable the horn, turn the and/or output. They accept standard
knob counter clockwise until the Speakond type speaker cables. To
indicator reaches :. To set the horn
connect a cable: Insert and twist one
quarter turn clockwise until the release
for maximum output, turn the knob
button locks. To remove a cable: Pull
clockwise until the indicator reaches 0.
back release button on cable connector,
twist connector counter clockwise one
2 Speaker Input/Output:
These jacks can be used as an input
quarter turn, and pull out connector.
and/or output. The jacks accept a
Note: When using these jacks as an
output to another cabinet, refer to the
standard ¼” cable. Note: When using
Amplifier Loading Chart (page 4) for
these jacks as an output to another
important amplifier loading information.
cabinet, refer to the Amplifier Loading
Chart (page 4) for important amplifier
loading information.
4
HORN ATTENUATION dB
Designed by Kustom Inc. Cincinnati, Ohio
MADE IN CHINA
+1 tip, -1 sleeve
INPUT/OUTPUT
+1 and -1 used
0
1
2
3
5
6
7
8
10
12
16
MODEL: G410H
XXXX-XXXXXX
IMPEDANCE:8 OHMS
POWER: 1000 WATTS RMS
SENSITIVITY:95dB 1W/1M
1
2
3
Rear Panel