Kustom DE200HD Stereo Amplifier User Manual


 
5
Back Panel:
Speaker Output Jacks (A)
These 1/4” jacks are used to connect speaker cabinets to the amplifier. Note: The minimum load for
this amplifier is 4 ohms.
Line Output Jack (B)
This 1/4” jack is used to connect the amplifier to another line level piece of equipment, such as a mixer.
The output from this jack is after the preamp, so all of the controls on the amplifier will affect the sound
from this jack.
Effects Return Jack (C)
This 1/4” jack is used to connect an external effects processor to the amplifier. The output of the effects
processor should be connected to this jack. Note: This jack can also be used as a power amp in jack.
Effects Send Jack (D)
This 1/4” jack is used to connect an external effects processor to the amplifier. This jack should be
connected to the input of the effects processor. Note: This jack can also be used as a preamp out
jack.
Model DE200HD Bass Amplifier
200W 4 ohm @ 5% THD
Output Power
120W 8 ohm @ 5% THD
Frequency Response
20Hz - 19 kHz Actual response is tailored to speaker cabinet for
accurate acoustical response.
Total Harmonic Distortion
Less than 0.4% Measured at 1VRMS (0dBv) at direct output, effects
send, or line output
-60dB Residual Noise, all level controls 0% (minimum)
Hum & Noise
-50dB Nominal System Noise, all level controls at 50%
All measurements made at 1kHz
40dB CD/Tape Input to Power Amp Out
60dB Bass Input to Power Amp Out
-5dB CD/Tape Input to Line Output
40dB Bass Input to Line Output
-5dB CD/Tape Input to Direct Output
System Gain
40dB Bass Input to Direct Output
Equalization 63 to 5kHz, 6 Band Graphic, all ±12dB
Power Requirements USA/Canada 120VAC/60Hz, 300W nominal
Europe 230VAC/50Hz, 300W nominal
UK 230VAC/50Hz, 300W nominal
Australia 240VAC/50Hz, 300W nominal
Japan 100VAC/50-60Hz, 300W nominal
Dimensions mm
inches
89 (Height) x 482 (Width) x 245 (Depth)
3 1/2 (Height) x 19 (Width) x 9 3/5 (Depth)
Weight kg/lbs 7 kg / 15 lbs
Specifications