Krell Industries KBL Stereo Amplifier User Manual


 
When the control is turned clockwise the left channel is attenuated;
when turned counterclockwise the right channel is attenuated.
The LED indicators may illuminate at high listening levels. This
indicates that a level difference exists between the left and right
channels at that moment. This can be disregarded unless there is an
audible channel imbalance.
2. Two KBL Operating in Dual-Mono
When two KBL are used for dual-mono operation the Symmetry
control adjusts for differences in level between the non-inverted and
inverted outputs. When there is an imbalance between the two
outputs one of the LEDs will illuminate to indicate the output that is
lower in level. Turn the control in that direction until the LED goes
out. This may or may not occur in both channels at the same time.
The LEDs can be disabled if desired. See section D, 5 above for details
on turning off the LEDs.
Use the level control to adjust the listening level.
When two KBLs are used the level controls on the two preamps also
control the balance between left and right channels.
F. WARRANTY
The KBL and KPA have a limited warranty of five years from the date of
purchase. Please return completed warranty cards for each unit
immediately after successful installation and operation are completed.
The warranty for all Krell product is valid in the country to where it was
originally shipped and at the factory. If there are problems with your
unit(s) please contact your dealer or the factory immediately.
Should your unit need to be repaired, contact the factory or your distributor
for a return authorization. Freight to the factory or distributor is your
responsibility. Return freight to you will be paid by the factory or
distributor.
9/11/90
16