Filter
Top Products
that the next source played will not dam-
age your system with a high output tran-
sient.
A description of the buttons on the
KAV-250p and the KAV-250p remote is
provided below.
PWR Power On/Off Button
AVOLUME Raises volume
¯’VOLUME Lowers volume
¯ L Bal R (remote control only)
Shifts the balance to the left in ldB incre-
ments. The "1" position mutes the right
channel.
¯ L Bal R (remote control only)
Shifts the balance to the right in ldB incre-
ments. The "R" position mutes the left chan-
nel.
BALANCE and LEVEL
When either the "12 or the "R" on the
Balance control button is pressed on the
remote, the Balance led on the KAV-250p
will illuminate and the volume control leds
convert to a Balance control indicator. The
center led (Level) will always remain dimly
illuminated indicating the center balance
position. As balance is adjusted either left or
right, another more brightly lit led illumi-
nates to indicate the now modified balance
setting. After 5 seconds of inactivity or a vol-
ume adjustment, the leds revert back to vol-
ume control indicators. If the Balance has
been set to an off-center position, the
Balance led will remain lit after the adjust-
ment period. If returned to a centered
Balanced position, the Balanced led will
extinguish after the adjustment period.
MUTE (front panel only)
Press the input button of the active source
to mute the output.
UNMUTE (front panel only)
Press the input button of the active source
again to unmute the input. If the active
source is changed while the KAV-250p is
muted, press the input button of the new
active source a second time to unmute the
KAV-250p.
MUTE (remote control only)
Press the mute button of the remote to mute
the output of the active source.
UNMUTE (remote control only)
Press the mute button of the remote to
unmute the output of the active source.
NOTE: When the mute led on the KAV-250p
is illuminated, there is no signal output.
B-1 Selects the B-1 input
S-1 Selects the S-1 input
S-2 Selects the S-2 input
S-3 Selects the S-3/PR input*
TAPE Engages the tape monitor
Battery Installation and Removal
NOTE: Batteries should be replaced when
functions from the remote control become
intermittent. The KAV-250p remote uses
two AAA size 1.5 volt batteries.
1. Remove the backplate to expose the
batteries.
2. Remove the old batteries.
3. Install the new batteries, following the
battery position diagram on the plastic
battery receptacle.
4. Re-install the backplate.
5.
Check to make sure the remote control
is functioning properly.
*See Optional Configurations, on page 8.
Page 6 of 12 English
KRELL
®
KAV-250p