Filter
Top Products
12
Placement
Before you install an Evolution amplifier into your system, please follow the guide-
lines in this section to select a location for your component. This will facilitate a
clean, trouble-free installation.
Place the amplifier on a firm, level surface, away from excessive heat, humidity, or
moisture. Each Evolution amplifier requires at least two inches (5 cm) of clearance
on each side and at least eight inches (20 cm) of clearance above the component
to provide adequate ventilation.
If you place the amplifier in a closed cabinet, you may need to modify shelf spac-
ing or use small fans to increase ventilation. When the front and back of a cabinet
are open, the air space between the chassis and shelf must be unobstructed.
Place the amplifier(s) as close to the loudspeakers as possible. While Evolution
CAST technology permits long interconnect cable lengths, keep loudspeaker
cable lengths to a minimum.
AC Power Guidelines
The Evolution amplifier requires a dedicated AC circuit rated at a minimum of 20
amps. Do not use extension cords, multiple AC adapters, or AC power strips.
Note
Do not operate the Evolution amplifiers with any device designed to alter or condition
AC power.
(SECTION TWO: Unpacking and Placement continued)