Filter
Top Products
Using Your WP-500
5
5
4.1 The USB Port
Use the USB port to configure
1
5 Using Your WP-500
the unit. You can access the USB port by
removing the two adjustment knobs and unscrewing the four front panel screws.
This user manual is applicable once the unit is installed and configured
2
This section describes how to:
. The
installation process is not detailed in this user manual, and includes configuration
via the Kramer K-Config Windows®-based configuration software.
• Connect the WP-500 (see section
5.1
)
• Control the WP-500 (see section
5.2)
5.1 Connecting the WP-500
To connect the WP-500, as illustrated in the example in
Figure 3 (front panel)
and
Figure 4 (rear panel), do the following:
1. On the front panel (see
Figure 3), connect:
A computer graphics source and the audio source of the computer to the
PC 1 15-pin HD and 3.5mm mini jack, respectively
A computer graphics source and the audio source of the computer to the
PC 2 15-pin HD and 3.5mm mini jack, respectively
A composite video source (for example, a DVD player) and the audio
source of that composite video source to the VIDEO (PC) RCA and
AUDIO LEFT and RIGHT RCA connectors, respectively
A microphone to the MIC IN 3.5mm mini jack (see section
5.1.1)
1 By the system integrator only
2 By authorized Kramer technical personnel or by an external system integrator