Filter
Top Products
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Using Your 7508 CV/YC to SDI Converter
8
5.2 Setting the DIP-Switches
Configure the 7508 unit by setting the DIP-switches, as shown in
Table 2
and
Figure 5.
Table 2: Setting the DIP-Switches
DIP-Switch
Set as Follows:
1 Y/C ON for Y/C source; OFF for CV source
2 RESERVED OFF
3 PEDESTAL
1
ON for pedestal (7.5 IRE offset selection for NTSC); OFF for no pedestal
AUTO NTSC PAL PAL-M PAL-N NTSC-4 SECAM AUTO
4 STANDARD 1 OFF ON OFF ON OFF ON OFF ON
5 STANDARD 2 OFF OFF ON ON OFF OFF ON ON
6 STANDARD 3 OFF OFF OFF OFF ON ON ON ON
7 RESERVED OFF
8 PROGRAM ON for upgrading firmware; OFF for normal use
Figure 5: DIP-Switch Settings
1 NTSC offsets the black level within the active video signal by 7.5 IRE when selected