Kompernass KH 2331 CD Player User Manual


 
4
GB
5
GB
PLL CD player with radio and MP3
KH 2331/2332/2333
Intended use:
The device is suitable for playing back Audio
CDs, CD-Rs, CD-RWs and MP3-CDs.
It is also used for receiving MW and UKW radio
transmissions.
Not intended for commercial use.
Operating elements:
Volume control (Setting playback volume)
Equalizer key (Equalizer function)
STOP key (Stopping playback)
MEMORY/ PROG. key (Track program-
ming/allocation of up to 64 storage spaces)
REPEAT key (repeated playback)
R-SKIP key (CD skip track/
Search /Rewind key)
F-SKIP key (CD skip track /Search /
Forward key)
CD PLAY/ CD PAUSE key (start/ pause
playing back)
POWER key (Switch on/off the device)
µ Function switch TUNER / BAND; *MONO / ST.
(Switch on radio operation/ Wave range
selection/ MONO/ STEREO play back.)
¸ FIND key (MP3-CD: Display of the track
search function)
¹ Display
Ƹ ALBUM / PRESET+ key (MP3-CD/CD:
Selecting the next album/
radio: Selecting the next saved radio
transmission)
ƹ ALBUM / PRESET key (MP3-CD/CD:
Selecting the previous album/ radio:
Selecting the previous saved radio
transmission)
ƺ Headphone socket
ƻ UKW antenna
Ƽ Type label
ƽ Mains connection
ƾ Battery compartment
ƿ TIMER key (Model KH2331)
ƿ! SLEEP key (Model KH2331)
Technical data:
Rated voltage: ....................230V AC / 50 Hz
Power consumption :..........18 Watt
Max. output rating: ............2 x 2 Watt
Battery operation: ..............8 x UM-1 battery/
2 x UM-3 battery
(Memory backup)
Model KH2331: ..................8 x UM-2 battery/
2 x UM-3 battery
(Memory backup)
Radio operation: ................MW: 522 - 1620 KHZ
UKW: 87.5 - 108 MHZ
CD player: ..........................CD, CD-R, CD-RW,
MP3-CD
Headphone socket: ............Stereo / 3.5 mm
Safety instructions:
Danger! Electric shock!
•Warning: Do not operate the device, if the
power plug, power cord or the device is
damaged.
If the device falls of, get it checked by an
electrician befire you operate it again.
•Prevent liquids from seeping into the device.
In case of emergency, pull out the power
plug immediately.
Do not use the device in wet areas (e. g.
Bathroom) or areas with a lot of dust
accumulation.
Do not remove the cover under any circum-
stances. The components inside the device
are not intended to be maintained by the
user. Repairs are to be carried out exclusively
by a specialist firm or the service centre.
Do not place the device in direct proximity
of inflammable material (e.g. curtains,
inflammable liquids, etc.).
•To disconnect the device from the power
supply completely, pull out the power plug
out of the power socket and whicle doing
so, always hold the connector and not the
cable.
•Check the power cord regularly for possible
damages.
Important: Before the initial use, remove the
protective cap from the CD slot.
Danger! Laser radiation!
The CD player has a "Class 1 Laser“.
Never open the device.
Never attempt to repair the device. There is
invisible laser radiation inside the device.
Do not expose yourself to the laser beam.
ƽ Important! Fire hazard!
Do not expose the device to extreme tempera-
tures, as the heat built-up inside the device can
lead to defect and/or fire.
•Avoid direct solar radiation.
Do not cover the ventilation slots of the
device.
Leave a minimum free space of approx.
10 cm on the sides.
Do not place any open sources of fire, like
candles, on the device.
Power supply
Mains operation:
Check whether the voltage of your device
and the local voltage are identical.
If you want to operate the device on a 230V
household network power socket:
Plug the power cord into the adaptor ƽ
provided on the rear side of the device.
Plug the power plug into the power socket.
Battery operation:
Note: Always use new batteries of the same
type while changing batteries.
Batteries with values that have not been
recommended can damage the device.
Never try to open the batteries.
Never expose the batteries to extreme
amount of heat and never throw them into
fire.
Always dispose off the batteries in an envi-
ronmentally compatible manner. Contact
your local authorities for the purpose.
Inserting the batteries: (The power plug is to
be removed)
Insert the eight batteries
(TYPE UM-1/Model KH2331: TYPE UM-2)
and the two batteries (Type UM-3 „AA“) into
the battery compartment ƾ on the undersi-
de of the device. Make sure that the plus
(+) and minus (-) poles of the batteries have
rightly been placed in the indicated places.
Note:
Power Standby
If the device is being connected to the power
socket for the first time, it switches on to the
standby mode.
Press the POWER key to switch on the
device. The device remains in the standby
mode until it is switched on.
Pull out the power plug in order to complete-
ly switch off the device.
Setting the time
In the standby mode
1. Press the MEMORY/ PROG. key for two
seconds in order to set the time. The "12
HOUR“ display appears in the display.
2. Press the F-SKIP or the
R-SKIP key to select the 12/24 hour display.
Confirm the selection by pressing the
MEMORY/PROG. key again. The first two
digits flash in the display.
3. Press the F-SKIP or the
R-SKIP key to set the current hour. Confirm
the selection by pressing the MEMORY/PROG.
key again. The last two digits flash in the
display.
4. Press the F-SKIP or R-SKIP key to set
the current minutes. Confirm the set time by
pressing the MEMORY/PROG. key again.
Operation/ Radio operation
Set up the antenna ƻ and if necessary, adjust it to
receive better radio reception.
Transmission search
1. Press the POWER key to switch on the
device.
2. Press the TUNER/BAND µ key. The radio
switches on.
3. Press the TUNER/BAND µ key again to set
the transmission range (MW/UKW).
KH2331-2333_Boomboxen_UK 02.03.2005 14:03 Uhr Seite 4