Filter
Top Products
- 10 -
Alarm Function
You can programme in two alarm times, and then
be woken by either the DAB radio, FM radio or one
of two different alarm signals.
Note:
In mains operation the functions alarm, snooze and
sleep are available without restriction.
In battery operation only the sleep function is available
without restriction. An alarm can of course be
programmed with a switched on radio, however,
it does not switch itself on from the standby mode.
Setting the alarm time
Note:
If no further input is made within 10 seconds, the display
indicates once again the previous mode of operation.
1. Press and hold the buttons
ALARM1 or ALARM2 to
programme the respective alarm. In the display
the indicators Alarm 1 Time Set resp. Alarm 2
Time Set and the alarm time appear. The minute
figures blink.
2. Turn the multi adjustor
VOLUME/SELECT to programme
in the minutes. Press the button
JOG MODE/SELECT.
The hour figures blink.
3. Turn the multi adjustor
VOLUME/SELECT to programme
in the hours. Press the button
JOG MODE/SELECT.
4. Turn the multi adjustor
VOLUME/SELECT to choose
between the alarm signals BEEP TONE1 or BEEP
TONE2. Press the button
JOG MODE/SELECT.
5. Turn the multi adjustor
VOLUME/SELECT to programme
in a saved position 1-10 (DAB-Preset) for the
DAB mode. Press the button
JOG MODE/SELECT.
6. Turn the multi adjustor
VOLUME/SELECT to programme
in a saved position 1-10 (FM-Preset) for the FM
mode. Press the button
JOG MODE/SELECT.
7. Turn the multi adjustor VOLUME/SELECT to programme
in a sound volume (Volume Level) from 1-20.
Press the button
JOG MODE/SELECT.
The alarm time is now programmed. To activate the
alarm, read the next section.
Activating the alarm
• Repeatedly press the button ALARM1 resp. ALARM2
to adjust the appropriate alarm as follows:
ON BEEP Alarm activated by alarm signal
ON DAB Alarm activated in the DAB mode
ON FM Alarm activated in the FM mode
OFF Alarm switched off
Note:
For an alarm call in the DAB mode a sender MUST
be programmed in at the selected save location.
If a sender is not saved there, then the alarm switches
itself on with a signal tone.
Note:
When the alarm is activated, a quadrat appears in
the upper left corner of the display.
• With the device switched on, repeatedly press
the button
INFO until the indicator Alarm 1 Status
or Alarm 2 Status appears, to display the alarm
adjustments.
With an activated alarm, at the adjusted alarm time the
signal tone resp. the radio sounds for one hour.
• Terminate the alarm by pressing the button
STANDBY/
ON, or deactivating the alarm by pressing the
appropriate button
ALARM1 resp. ALARM2.
Snooze Function
With the snooze function you can extend the alarm
time in 5 minute steps.
• Press the button
SNOOZE when the alarm sounds.
In the display the time and Z is indicated.
The alarm stops and sounds again after 5 minutes.
After one hour the alarm switches itself off.
IB_KH2314_AR23585_LB3C 08.09.2008 15:44 Uhr Seite 10