Kompernass KH 2022 Stereo System User Manual


 
Receive Mode
a) Switching the appliance on/off, button lock
To switch the appliance on, press on the ...
button “FM ON”
·, if you wish to receive VHF transmissions.
button “AM ON”
», if you wish to receive MW or SW 1-7 transmissions.
The green LED “POWER”
² glows for as long as the appliance is switched
on.
To switch the appliance off, press the button “POWER OFF”
.
With the sliding switch ”HOLD”
ƾ you can block all buttons against
adjustment (ON), or have them free for adjustment (OFF).
b) Adjusting the reception
If you have switched the appliance on using the receiving mode button
“AM ON”
», first of all select either the reception range MW (Medium
Wave) or SW 1-7 (Short Wave). For this, push the waveband selector
¿
into the relevant position.
Then search for the desired radio station by slowly turning the tuning re-
gulator “TUNING”
Ƽ until you have clear reception. In the display ´
the frequency just received is shown digitally, together with the unit
“MHz” (Megahertz) or “kHz” (Kilohertz).
c) Adjusting volume and sensitivity
Set the desired volume level using the volume regulator “VOL”
ƹ .
With MW and SW 1-7 you can adjust the reception sensitivity. Slide the
switch “LOCAL/DX”
ƽ to the position “LOCAL” if you only want to receive
powerful local transmissions. In the position “DX” the receiver is adjusted
for worldwide reception.
d) Switching the display illumination on
Hold the button “LIGHT”
Ƹ pressed down to switch on the display illumi-
nation.
- 7 -
IB_KH2022_AR2503_4a.qxd 26.02.2008 9:30 Uhr Seite 7