Filter
Top Products
9
To turn off the zone either push the keypad button labeled off or the off button on the RB8 remote
control.
To turn on the zone on either press the source button or the off button on the remote or keypad. If
you press the OFF button the zone will go back to the source selected when it was last shut off.
In either case the zone goes to a preselected mid-low volume, not necessarily the volume
selected when it was last shut off.
To adjust the volume press the volume switch up or down as desired. The relative volume is
shown in the led displays on the top.
To temporarily mute the output, press the mute button on either the remote or keypad. It mutes
the output in this room.
Equalization (if required).
Equalization cannot be performed from the remote control. To enter the equalization mode press
the FNC button. The four source button will have their led’s running in a circular motion. To raise
the bass output in this room only push and hold the source 1 button until the desired effect is
achieved.
When the maximum bass is selected the OFF button will blink. Do the same with bass down,
treble up and treble down. The parameters selected go into memory and are retained even if the
power to the system is turned off.
Press the FNC button again to exit the equalization mode.
To go back to a flat frequency response, enter the equalization mode again and when in this
mode with the source leds going in a clockwise direction press the MUTE button. The
equalization is now flat. Again to exit this mode press the FNC mode and
Knoll Systems service information
The GSZ44 amplifier does not contain any user serviceable parts inside. If you suspect a
problem that may require servicing, contact us at www.knollsystems.com/contact.html, or by
phone at 800 566-5579. It is extremely important that only an authorized service dealer make
any repairs. This will ensure proper service and preserve the protection of your warranty.
Keep your receipt in a safe place so that it will be available to verify the purchase date, should
you experience a problem covered by Knoll System’s warranty.
Troubleshooting
Your Knoll amplifier is designed from trouble-free operation. If you follow the
instructions in this manual, you should enjoy many years of high-quality listening
enjoyment. However, as with any sophisticated device, there may be occasional
problems upon initial installation, or during the life of the amp. The items on the list
below are a brief guide to the minor problems that you may be able to correct
yourself. If these solutions do not help, or if the problem persists, contact us for
assistance at 1800 566 5579 in Canada or the USA or 604 272 4555. We are in the
Pacific time zone.