Filter
Top Products
RIGHT channel input (refer to Figure 4). Take care to ensure
that no bare wires from any of the connections touch any other
terminals, as this could cause a short and damage your equipment.
“LINE IN/LFE” – This input is filtered by the built-in “Low Pass”
(LP) crossover and is designed as a general purpose input for
the subwoofer. It accepts the LFE signal output of your digital
surround electronics. See optimal connections above.
“LOW PASS” (LP) Control – This control allows the user to select
the upper frequency cutoff of the subwoofer. Frequencies above
the control setting are filtered out, allowing you to blend the
subwoofer’s output with that of your main speakers. The frequency
is selectable from 40-150Hz. For sources with an LFE output
or that use an internal crossover, the lowpass filter should be
defeated by setting the control to “BYPASS”.
“VOLUME” – This control serves as an overall volume control for
the subwoofer. It is used to match the output level of the subwoofer
to the main speakers.
“PHASE” 0/180 – This control is used to acoustically match the
subwoofer’s output to your main speakers. Select the position
either 0˚ or 180˚ in which your subwoofer has more output at the
listening position.
Off/Auto/On – When this switch is in the “ON” position, the
subwoofer will remain on at all times. When this switch is in the
“AUTO” position, the subwoofer will automatically turn “on” when
it senses a signal. It will automatically go into “standby mode”
after 15-20 minutes with no signal. When this switch is in the
“OFF” position, the subwoofer will remain “off” until the switch is
manually turned back to the “ON” or “AUTO” position.
LED indicator– Klipsch SW subwoofers have an LED indicator
on the front that indicates the status of the built in amplifier. The
LED will light blue when the amplifier is on and receiving a signal.
When the unit is in standby mode or turned off, the LED indicator
will turn off.
Your subwoofer has a durable vinyl finish that should only require
dry dusting or cleaning with a dry cloth. Avoid the use of abrasive or
solvent-based cleaners and harsh detergents. The brush attachment
of your vacuum should remove any dust from your subwoofer
enclosure.
Care and Cleaning
3
• Klipsch will keep you up-to-date on new products and promotions
• Your personal information will never be resold
Register your product online at
www.klipsch.com/register
Product Registration Benefits