Filter
Top Products
CONNECTIONS
Conventional Connection – Using 20-16 gauge speaker wire,
connect the RED “positive” (+) terminal of the LEFT speaker to
the RED “positive” (+) terminal of your amplifier’s LEFT chan-
nel. Connect the BLACK “negative” (-) terminal of the LEFT
speaker to the BLACK “negative” (-) terminal of your amplifier’s
LEFT channel. Repeat this procedure for connecting all remain-
ing speakers to the appropriate amplifier channels. Refer to
Figure 4. Make sure no bare wires from any of the connections
touch any other bare wires or terminals as this could cause a
short and damage your equipment.
Amplifier Requirements – Klipsch speakers are
highly efficient and will work well with a wide variety
of amplifiers. Due to the high output levels Klipsch speakers are
capable of reproducing, exercise caution with the volume control.
Excessive volume over long periods of time can permanently
damage your hearing. Overdriving your amplifier could also
damage your speakers. Check with your dealer to make sure
your particular amplifier is best suited to your application.We want you
listening for a lifetime.
NOTE: The A/V receiver/surround sound processor must
be set
to “Subwoofer On” and all speakers set to “small”.
The suggested crossover point is 150 Hz. If 150 Hz is not avail-
able, use 120 Hz.
CARE AND CLEANING
Your speakers have a durable finish that should only require dry
dusting. Avoid use of abrasive or solvent-based cleaners and
harsh detergents. The brush attachment of your vacuum or a
damp cloth should remove any dust from your speaker grilles.
EU Compliance Information
Eligible to bear the CE mark, Conforms to European Union Low
Voltage Directive 73/23/EEC and 2006/95/EC; Conforms to
European Union EMC Directives 89/336/EEC and 2004/108/EC.
WEEE Notice
Note: This mark applies only to countries within the European
Union (EU) and Norway.
This application is labeled in accordance with
European Directive 2002/96/EC concerning waste
electrical and electronic equipment (WEEE). This
label indicates that this product should not be dis-
posed of with household waste. It should be
deposited at an appropriate facility to enable
recovery and recycling