Filter
Top Products
l abc
9
19. is supplied via an IEC standard 3-pin connector. A compatible power cord is supplied with the
unit.
20. The is located in a fuse holder fitted to the rear panel. Always replace with the correct type
and rating as indicated on the unit.
21. This unit is switchable between two nominal supply voltages, 110V and
220V, via a slide switch. The switch MUST be set before the supply is connected. Any attempt to run
the unit from a 220V supply with the switch set to 110V is liable to result in severe damage to the unit.
Mains
mains fuse
Voltage selector switch.
Note: Units for the Japanese market do not have an accessible mains voltage selector switch and are set for 100V
operation only.
22. Signal is made via a female XLR type connector.
23. Signal is available on a male XLR type connector. For wiring details see page 11 of this
manual.
24. is made via a ¼ inch typeA stereo jack connector.
25. is made via a ¼ inch typeA stereo jack connector.
26. Always quote the in any correspondence concerning the unit.
Input
Output
Expander Side Chain Input
Compressor Side Chain Input
Serial Number
Instrument Familiarisation: Rear Panel Controls
20
21
22
26
24
25
23
19
CUS
NEUTRIK
1
2
3
NEUTRIK
1
2
3
NEUTRIK
1
2
3
NEUTRIK
1
2
3
115/220-240V