Filter
Top Products
3
Model External Fuse
(sold separately)
Power/Ground Wire KICKER Wiring Kit
ZX1000.1 1 x 100 Ampere 1/0 Gauge PKD1, PK4, CK44, ZCK44
ZX1500.1 1 x 150 Ampere 1/0 Gauge PKD1, PK4, CK44, ZCK44
ZX2500.1 1 x 300 Ampere 1/0 Gauge PKD1, PK4, CK44, ZCK44
output to the stereo RCA input on the end panel of the amplifi er using RCA interconnect cable. If a low-level
stereo RCA output is not available on the source unit, the signal can be delivered to the amplifi er using the
high-level speaker outputs on the source unit. Set the input level switch on the end panel of the amplifi er to “HI”.
Crimp and solder RCA connectors to the end of the speaker wire running from the high-level speaker outputs
on the source unit and connect the wire to the RCA Inputs on the end panel of the amplifi er or simplify the
installation by using a KICKER ZISL as shown below. Either input method will provide a low-level output signal
at the RCA output, which effectively passes the audio signal to another amplifi er or component. Keep the audio
signal cable away from factory wiring harnesses and other power wiring. If you need to cross this wiring, cross it
at a 90 degree angle.
source unit
high-level speaker
outputs
to amplifi er
shield
+
–
core conductor
GND REM +12V
12V
battery
external fuse
remote turn-on
(see page 5)
bare-metal
chassis ground
18”
(45cm)
24”
(60cm)
Install a fuse within 18” (45cm) of the battery and in-line with the power cable connected to your amplifi er. If you
ever need to remove the amplifi er from the vehicle after it has been installed, the ground wire should be the last
wire disconnected from the amplifi er--just the opposite as when you installed it.
KICKER ZISL
source unit high-level
speaker outputs
OR
to amplifi er
protection LED
2010 ZX 1000.1 1500.1 2500.1 RevD.indd 32010 ZX 1000.1 1500.1 2500.1 RevD.indd 3 10/15/2009 11:05:20 AM10/15/2009 11:05:20 AM