Filter
Top Products
6
SS Component Systems
Parts List
TINNERMAN CLIPS Steel spring anchor
used as anchor point for
screws if required.
BUTT CONNECTORS Insulated crimp
connectors to connect a 16
gauge wire to another 16
gauge wire.
WIRE BUNDLES 3 sets of high quality 16
gauge speaker wire to
connect your SS Series
Components to the
crossover and amplifier.
R-TOOL Tool used to assist in tightening
or loosening the Tweeter
Grill Mount Ring.
Shown is an example
of how the prongs in the
R-Tool line up in the
holes of the rings. Once
in place you use the
R-Tool to tighten or
loosen the ring.
MIDRANGE DRIVER BOOT Protects the
magnet and motor
assembly of the
Midrange Driver.
(Already attached to the midrange and is
removable.)
MIDRANGE GRILL Grill used to protect
the driver when doing a
high-lighted installation
or mounting through a
panel.
COMPONENT CROSSOVER Two way
passive crossover to
split the audio signal
between the tweeter and
midrange.
ALLEN WRENCH Supplied tool used to
tighten and loosen wire
connections at the
crossover.
BEVEL HEAD SCREWS Supplied screws
to mount Midrange
Driver and crossover.