Filter
Top Products
4
Do not install a port opening against a solid surface, such as an internal brace, back-panel or trunk wall,
seat or interior panel of your vehicle. The port opening must remain unobstructed. Use the smallest
dimension of the rectangular port as the minimum amount of space between the port opening and any
solid surface to insure unrestricted airfl ow.
If you prefer an ultra-smooth bass response, you should loosely fi ll your L3 enclosure with poly-fi l
stuffi ng. Ported designs will require covering the end of the port (located inside the box) with grill cloth,
chicken wire, or expanded metal to prevent the poly-fi l from exiting the port. The use of poly-fi l will slightly
decrease effi ciency, but will deepen and extend the low frequency output.
For more advice on box building, refer to your Authorized Kicker Dealer, or click on the Support tab on
the Kicker homepage, www.kicker.com. Please e-mail support@kicker.com or call Technical Support at
(405) 624-8583 for specifi c or unanswered questions.
Y
X
Z
D
DD
Figure 3 Figure 4
D = 3” x 3” for S12L3, S15L3
D = 2” x 2” for S10L3
SEALED ENCLOSURE APPLICATIONS
Model Volume ft
3
(L) Panel A in. (cm) Panel B in. (cm) Panel C in. (cm)
S10L3 .8 (22.7) 13.5X13.5 (34.3X34.3) 13.5x10.125 (34.3x25.7) 12x10.125 (30.5x25.7)
S12L3 1.25 (35.4) 14.5X14.5 (36.8X36.8) 14.5x12.75 (36.8x32.4) 13x12.75 (33x32.4)
S15L3 1.8 (51) 17.25x17.25 (43.8x43.8) 17.25x13.5 (43.8x34.3) 15.75x13.5 (40x34.3)
Model Volume ft
3
(L) Power Handling
S10L3 .8 (22.7) 400W RMS
S12L3 1.25 (35.4) 400W RMS
S15L3 1.8 (51) 500W RMS
Model Volume ft
3
(L) Power Handling
S10L3 3 (85) 300W RMS
S12L3 4.6 (130) 300W RMS
S15L3 5.2 (147) 500W RMS
Panel Dimensions for Compact Sealed Enclosures using 3/4” (1.9cm) thick MDF (See Figure 5)
Sealed Compact
Sealed SQ
2011 L3 Multilingual Rev B.indd 42011 L3 Multilingual Rev B.indd 4 10/19/2010 2:08:25 PM10/19/2010 2:08:25 PM