Filter
Top Products
6
Solo-baric L5 Subwoofers
Installation
Box Building Notes
The cardboard “Template” inside your Solo-Baric’s shipping
carton can be used as a pattern for cutting the speaker mounting
hole in your enclosure. The cardboard template is the same size
as the L5 basket. After marking your baffle with the template,
make sure to cut directly on the line. This will maintain the proper
baffle cut-out size for the L5 basket.
All the cubic feet numbers given in the following pages include
the displacement of the woofer. For the ported enclosures the
displacement of the port must be added to the final design. It will
be impractical to use round ports for these designs. The listed
rectangular port information will yield the best results.
Always use 3/4" (1.9 cm) or thicker MDF (Medium Density
Fiberboard) and make sure all the joints are fastened and well
sealed. The peak pressure in a ported box can exceed that of a
sealed enclosure. All of these designs need some internal
bracing. Add 2" x 2" (5 cm x 5 cm) to 3" x 3" (8 cm x 8 cm)
triangle braces between each of the larger unsupported panels.
Kicker recommends using a high-grade wood glue and silicone
sealer for an airtight box.
X
X
X
x = 3" x 3" for S15L5, S12L5
x = 2" x 2" for S10L5, S8L5
Note: If you prefer an ultra-smooth bass response, you should
loosely fill your Solo-Baric enclosure with poly-fil (polyester
fiberfill) stuffing. Ported designs will require covering the end of
the port (located inside the box) with grill cloth, chicken wire, or
expanded metal to prevent the poly-fil from being blown out of
the port. The use of poly-fil stuffing will slightly decrease
efficiency, but will deepen and extend the low frequency output.
Do not install a port opening against a solid surface, such as
an internal brace, back-panel or trunk wall, seat or interior panel
of your vehicle. The port opening must remain unobstructed. Use
the smallest dimension of the rectangular port or the diameter of
the round port as the minimum amount of space between the
port opening and any solid surface to insure unrestricted airflow.
For more advice on box building, click on the SUPPOR
T tab
on the Kicker homepage, www.kicker.com. Choose the
Technical Support tab, choose the Tech Manuals tab, and then
download or view the corresponding information. Please E-mail
support@kicker.com or call Technical Services (405) 624-8583
for specific or unanswered questions.
A Note on Power Handling Capacity
Solo-Baric subwoofers will handle massive amounts of power in
any of the recommended enclosures, minimum or maximum.
The smaller enclosures are best for use in limited-space
applications. The larger recommended enclosures will yield
slightly more bass at the lowest frequencies. The listed Power
Handling capacities assume that both voice coils are in use.
Always connect both coils in a dual voice-coil speaker.