Adjustments and Controls
Setting Gain Control
The gain control is provided for level matching purposes The control
does not
give the amplifier any more power by turning it up Its purpose is to adjust the
sensitivity of the amplifier in relation to the output level provided by the source
Start with the amp gain set to minimum by turning the control counter-
clockwise Turn the source level up until distortion is barely audible Then turn it
down slightly This will typically be at about 85% to 95% of full volume Raise the
amplifier gain until distortion is just audible The gain is now set correctly Check
the level with cd/tape and tuner to make sure the adjustment is correct for all
sources
Setting KICKEQTM Controls
The Bass and Treble controls on your Impulse Amplifier are provided to help
tune your system for ideal sound quality After the system is installed and the
vehicle is put back together, do a listening test with music that is typical of the
type you normally listen to
Initially set the tone controls on the source unit to flat and turn the K/CKEQTM
controls fully counter-clockwise Depending on your personal taste and the
speakers used in the system, you may want to increase the high or low
frequencies by turning the K/CKEQTM controls clockwise Remember that once the
vehicle is in motion there will be an apparent loss of bass due to the masking
effect of road noise
Do not attempt to make adjustments while the vehicle is in
motion
It is safer to pull off the road to make changes
Never change the crossover settings while the amplifier is on
A loud pop will
result which could destroy speakers or cause hearing loss
5
.-.