Kenwood XD-503 Stereo System User Manual


 
29
Basic section
4. Select the source to be recorded.
The input source component to
be recorded should be displayed.
÷ If a disc has already been loaded when the CD input is selected, it will starts
to play automatically. In this case, press the stop (7) key to stop it.
÷ When you select DVD/VIDEO (External input), adjust the input level. t
Select an input source other
than “TAPE A or B”.
1 Start recording.
2 Play (or tune) the input source to be recorded.
5. Start recording.
÷ If a disc has already been loaded
when the CD input is selected, it
will starts recording automatically.
÷ Even if deck A is selected, it is
automatically switched to deck B
at the start of recording.
÷ Recording stops automatically
when the tape side(s) to be re-
corded have been fully recorded.
÷ Press the stop (7) key of the cas-
sette deck unit to stop recording
(see the next page).
Lights
Let's record
To pause recording
(Main unit only)
÷ Pressing the key pauses recording after leaving a
non-recorded space of about 4 seconds.
÷ If the key is pressed again in less than 4 seconds after it
has been pressed, recording resumes from that instant.
Each press switches the modes as follows.
1
” .... Recording stops after having re-
corded both sides of tape.
2
” ... Recording stops after having re-
corded both sides of tape.
3
..... Recording stops after having re-
corded one side of tape.
Selection of the reverse mode
Lights
÷ When the 2 transport direction indicator is lit,
recording always stops after having recorded one
side of tape.
REVERSE
MODE
REC/ARM
44
Press the desired key.
REC/ARM
55
C2D01 1:1
T.EQ
A
B
T.EQ
A
B