Kenwood XD-855E Stereo System User Manual


 
30
EN
CASSETTE OPERATION
TAPE A or TAPE B playback
1
Press the ON/STANDBY button to turn the
power on.
2 Press the TAPE (A/B) button.
3 Open the cassette door by pushing the area
marked “PUSH OPEN”.
4 Load the cassette into the TAPE A or TAPE B
cassette compartment.
5 With cassette in both decks, press the TAPE (A/
B) button to switch operation from one deck to
the other.
6 Press the 3 button to start playback.
When playback is performed using the remote
control, press the 3 button.
To stop playback :
Press the 7 STOP button.
Fast forward/rewind :
1 Press the 7 STOP button, then press the TAPE
(A/B) button to select TAPE A or TAPE B.
2 To advance the tape, press the P. CALL ¡ ¢
button. To rewind it, press the P. CALL 4 1
button.
Caution :
To remove the cassette tape, press the 7 STOP
button, and then open the cassette compart-
ment.
Before changing from one tape operation to an-
other, press the 7 STOP button.
If a power failure occurs during tape operation,
the tape head will remain engaged with the tape
and the cassette door will not open. In this case,
wait until power is restored.
Selection of reverse mode (TAPE B
only) :
Press the REVERSE MODE button repeatedly to
select the following setting :
....Playback stops after having played both
sides of tape in a deck.
“ .....Endless playback of both sides of tape.
“ .....Playback stops after having played one
side of tape.
4
4
1
2,5
3
6
P.CALL
4 1
¡ ¢
2,5
6
7
P.CALL
4 1 ¡ ¢
1
3
7 STOP
REVERSE
MODE