Kenwood XD-8550 Stereo System User Manual


 
XD-8550/XD-6000 (En/T)
70
Preparation sectionBasic sectionApplication sectionKnowledge sections
÷Adjust the present time again.
÷Adjust the present time again.
÷Adjust the present time referring to “Clock
adjustment”.
÷Set the timer ON time and OFF time.
÷Execute the timer program with the SRS
3D key.
÷Connect antennas.
÷Select a band.
÷Tune to the frequency of the desired sta-
tion.
÷Install the outdoor antenna in an apart posi-
tion from the road.
÷Switch the suspected electric appliance
OFF.
÷Install the TV or the system at an increased
distance between them.
÷Preset stations with tunable frequencies.
÷Preset stations again.
÷This is not malfunction. Press the DEMO
key to cancel the demonstration.
÷Cancel the AUTO POWER SAVE function.
÷Please consult your nearest KENWOOD
service station.
÷There was a power failure.
÷The power cord was unplugged from the
outlet.
÷The present time has not been adjusted or
there was a power failure.
÷The timer ON time and OFF time have not
been set.
÷The timer execution was not set up.
÷The antennas have not been connected.
÷A proper broadcasting band has not been
selected.
÷The frequency of the station to be received
is not tuned.
÷Car ignition noise.
÷Influence of an electric appliance.
÷A TV set is installed near the system.
÷The frequency of the preset station is not
tunable.
÷The preset memory has been cleared be-
cause the power cord has been unplugged
for a long period.
÷The power plug was unplugged from the
outlet while the power switch was ON, or
there was a power failure.
÷The AUTO POWER SAVE function is acti-
vated.
÷There is a certain trouble. The displayed
figure is variable depending on the details of
the trouble.
The clock display blinks without chang-
ing the figures.
Timer operation is not possible.
Radio stations cannot be received.
Noise interferes.
A station has been preset but it cannot
be received by pressing the P.CALL key.
Demonstration starts suddenly.
Power is turned OFF suddenly.
An error message is displayed
(ERROR * (figure))
In case of difficulty
RemedyCauseSymptom
Tuner/Equalizer Unit
Á
¨
6
º
º
P
¡
What seems to be a malfunction is not always so. Before calling for service, check the following table according to the
symptom of your trouble.
Operation to reset
The microcomputer may fall into malfunction (impossibility to
operate, erroneous display, etc.) when the power cord is un-
plugged while power is ON or due to an external factor. In this
case, execute the following procedure to reset the microcom-
puter and return it to normal condition.
÷Please note that resetting the microcomputer clears the contents
stored in and returns and to condition when it left the factory.
While holding the ENTER key depressed, unplug the power
cord and plug it again.
ENTER
C-H6 or C-H5