Filter
Top Products
XD SERIES (En/E2)
19
Preparation section Basic section Application section Knowledge sections
Operation
Loading batteries
2 Insert batteries. 3 Close the cover.
Plug the power cord of the amplifier unit (A-H5) into a
power outlet and press the ON/STANDBY (
) key of
the remote control unit to turn power ON. When the power
is turned ON, press the desired operation keys.
To turn power off, press the
(on/standby) key again.
The system enters the standby mode in which only the
time display is lit.
1. The provided batteries are intended for use in operation checking, and their service life may be short.
2. When the remote controllable distance becomes short, replace both of the batteries with new ones.
3. If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote sensor, malfunction may occur.
In such a case, change the installation position to avoid malfunction.
1 Remove the cover.
Operation of remote control unit
Notes
Notes
Model: RC-H7R
Infrared ray system
Operating range (approx.)
30°
6 m
Remote sensor
÷When pressing more than one remote control keys successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
÷Insert two R6 (“AA”-size) batteries
following the polarity indications.
30°